Setting The Marker Display - Sony F65 Operation Manual

e Color temperature
Indicates the state of the color temperature.
f SDI1 look
Displays the SDI1 look settings for the output image on the
SDI OUT1 connector.
g SDI2 look
Displays the SDI2 look settings for the output image on the
SDI OUT2 connector and in the viewfinder.
h Highlight clip indicator
Displays the highlight clip indicator status (On/Off).
Displayed only for the output image on the SDI OUT2
connector and in the viewfinder.
1) The signal output in the viewfinder is active only when SDI OUT2 is
selected as the signal source.
i Time code
Displays the time code.
j Recording status indicator
Displays "z" when the SR-R4 docked on the camera is
recording.
k Media remaining
Displays the approximate number of minutes remaining
for the recording media in the SR-R4 docked on the
camera.
l Power supply voltages
Displays the state of the output voltages. The output from
DC 24 V OUT is displayed on the left, and DC 12 V OUT
on the right.
The voltage readout begins to flash if the corresponding
input voltage falls to the Near End value specified on the
<Battery Alarm> page in the Config menu. The indicator
flashes more rapidly if the voltage falls to the End value.
m Message area
Displays a warning/error message if an error occurs. The
error details are also displayed in the self diagnostics field
in settings page 3 on the subdisplay.
For details about messages, see "Warning/Error
Messages" (page 66).

3-7-2 Setting the Marker Display

Various markers can be displayed in the viewfinder and on
the monitor.
Turning status/marker display On/Off for
each output
You can set whether to display status information and
markers in the signal output from the VF and SDI OUT
40
Viewing and Setting the Viewfinder Display
1)
connectors on the <Mix> page in the Display Info menu
(page 54).
<Mix> page
The default setting is to display status information and
markers in the signals from the VF and SDI OUT
connectors.
Item
[Status/Menu] VF/HD-Y
SDI OUT1
SDI OUT2
[Marker] VF/HD-Y
SDI OUT1
SDI OUT2
Color
Brightness Sets the marker display
Specifying the markers to display
When the marker display is turned On on the <Mix> page,
you select the markers for display on the <Marker> page in
the Display Info menu.
<Marker> page
The default setting for all markers is "Off."
Setting
Sets whether to display status
information in the VF connector
signal.
Sets whether to display status
information in the SDI OUT
connector signal.
Sets whether to display
markers in the VF connector
signal.
Sets whether to display
markers in the SDI OUT
connector signal.
Sets the display color of
markers.
brightness in the range 1 to 10
(maximum brightness is 10).