Roland VersaUV LEC2-330 Setup Manual page 27

Procedure
A
Attach the stand stay to the stand legs.
Position the stand legs so that their U-shaped brackets face the inside, and then tighten the bolts
securely (eight locations in total) in the order shown below. Loose bolts may cause the stand to wobble.
Temporarily tighten the bolts in the two upper locations. (On the left and right sides for a total
of four locations.)
After setting washers on the bolts, temporarily tighten the bolts in the two locations on the
sides. (On the left and right sides for a total of four locations.)
Fully tighten the bolts in the two upper locations. (On the left and right sides for a total of four
locations.)
Fully tighten the bolts in the two locations on the sides. (On the left and right sides for a total of
four locations.)
Tighten
temporarily →
tighten fully
Bolts: 8
Washers: 4
Position the stand legs
so that the U-shaped
brackets face the inside.
Place the stand stay on the stand legs as shown in the
following figure.
Make this gap
uniform.
Stand leg
Hexagonal
wrench
Bolt
Washer
Stand leg
Side
Stand stay
Hexagonal
wrench
Bolt
Stand stay
Stand leg
2. Assembly and Ink Filling
Washer
Top
Align these
parts so they
are parallel.
Stand stay
2.Installation
25