Albatron PX915P Series User Manual page 34

PX915P/ PX915G Series
Resources Controlled By
BIOS can automatically configure all the boot and Plug and Play compatible devices. If
you choose Auto, you will not be able to manually assign IRQ DMA and memory base
address fields, since BIOS automatically assigns them. Options: Auto (ESCD) (default)、
Manual
IRQ Resources
When resources are controlled manually, you can assign each system interrupt a type,
depending on the type of device using the interrupt. This is only configurable when
"Resources Controlled By" is set to "Manual".
Options: IRQ-3/ 4/ 5/ 7/ 9/ 10/ 11/ 12/ 14/ 15 assigned to PCI device
PCI / VGA Palette Snoop
Some graphic controllers that are not VGA compatible take the output from a VGA
controller and map it to their display as a way to provide boot information and VGA
compatibility.
Options: Disabled (default)、Enabled
PCI Latency Timer (CLK)
This item allows you to set up the PCI Latency Time (0-255). If you select the "32" it will
optimize PCI speeds. Options: 0-255、32 (default)
PCI SLOT1- 3
This item allows you to select an IRQ address for PCI slot 1-3.
Options: Auto (default)、3、4、5、7、9、10、11、12、14、15
**PCI Express relative items**
Maximum payload Size
This item allows you to set the PCI Express Maximum payload size per time. Options: 4096
(default)、128、256、512、1024、2048
Frequency/Voltage Control
Spread Spectrum
The Spread Spectrum function can reduce the EMI (Electromagnetic Interference)
generated. Options: Enabled (default)、Disabled
PCI Speed Setting
This item determines the PCI frequencY (speed settings). You can set the frequency using
the supplied BIOS options. One of the options available to you is "Auto". Using the "Auto"
option will instruct the system to automatically calculate the frequency.
Options: Auto (default)、33.0、37.7、44.0
30