Table of Contents
Advertisement
4.3.1
Search and Configure the ADAM-2000 Series
The ADAM-2000 series can be searched and configured through ADAM .NET Utility.
Make sure the ADAM-2000 devices are installed properly in Initial Mode. For more
information, please refer to the section 3.4.
The supported Wireless Sensor Networks Modules are listed in the information page
.
Figure 4.3 ADAM-2000 Series ADAM .NET Utility Support
If the user wants to use USB cable to connection with ADAM utility on PC, they need
to install USB chip driver in CD.
Step 1
Connect a USB cable between the ADAM-2520Z and the PC, and the system will
pop out message to install new device, find the USB folder to select USB chip driver
in out CD.
Base on your PC for 32 bit or 64 bit to select your suitable USB chip driver, then PC
will auto install. After install finished, you can see which port your system get in
device manager like bellow one. (Note: base on your system, this picture just for
sample)
Then restart the ADAM utility.
33
ADAM-2000 Series User Manual
Advertisement
Table of Contents
