Drive System; Drive Unit - Canon LBP1760P Service Manual

CHAPTER 3
II. DRIVE SYSTEM
A. Drive Unit
1. Removal from the printer
1) Remove the pick-up module.
2) Remove the top cover unit and right
cover.
3) Remove the multi-purpose tray.
4) Remove the screw and the claw, then
take out the envelope feeder gear cover.
Screw
Claw
Envelope feeder gear cover
Figure 3-2-1
5) Remove the main motor according to
the steps 1) through 3) in the main
motor removal procedures on page 3-9.
3 - 8
6) Remove the screw and release the
ground line from the cable guide.
7) Remove the screw and then the front
inner cover.
8) Disconnect all cables from the cable
guide.
Screw Ground line
Screw Front inner cover
Cables
Figure 3-2-2
9) Remove the fixing unit according to the
steps 1) through 5) on page 3-23.
10) Open the transfer guide, and remove
the screw.
Screw
Figure 3-2-3