CHAPTER 3
2. Removal of the envelope feeder dri-
ver PCB
1) Remove the bottom cover and the top
cover unit.
2) Disconnect the 2 connectors.
3) Detach the sensor lever at the front end,
leaving the rear end attached.
4) Remove the screw and the claw, and
take out the envelope feeder driver PCB.
Connectors
Sensor lever
Screw
Envelope feeder driver PCB
Figure 3-9-3
3 - 36
3. Removal of envelope pick-up sole-
noid
1) Remove the envelope feeder driver PCB.
2) Remove the screw and then the cover.
Screw
Cover
Figure 3-9-4
3) Undo the 2 screws, then take out the
envelope pick-up solenoid.
Screws
Envelope pick-up solenoid
Figure 3-9-5