Advertisement
Assembly
1. Make sure you have all the parts needed. If any
shortages are found, contact your Kasco representative
immediately.
2. Place loat on motor housing. The power cord notch on
the loat should line up with the cord. See diagram below
of bottom side of loat. The 3 bolt holes in the loat should
line up with bolt receptacles on unit.
power cord notch
3. Use one of the 1/4"-20 x 3-1/4" Phillips Pan Head
Screws, one 1/4" split washer, and a 1/4" Flat Washer to
secure the loat. Make sure the split washer goes between
the bolt head and the lat washer. Insert screw with washers
through bolt hole in loat. Tighten until snug with a Phillips
Head screw driver and repeat for 2 remaining screws.
4. Set motor housing and loat upside down on a lat
surface.
5. Bring the 3 bottom screen sections together.
4
6. Secure the 3 sections of the screen together in 6 places
using #8 screw, #8 lock washer, two #8 lat washers, and
#8 nut. Do not overtighten. Alternately, use cable ties
instead of hardware for a quicker assembly of the screen.
#8 screw
#8 lock washer
#8 lock washer
#8 screw
For quicker assembly:
Use cable tie instead
#8 flat washer
For quicker assembly:
Use cable tie instead
#8 nut
#8 flat washer
#8 nut
Advertisement
