Table of Contents
Advertisement
Ex
Explosion-proof Dome·Quick Start Guide
A few device components (e.g., electrolytic capacitor) require regular replacement. The
average lifespan varies, so periodic checking is recommended. Contact your dealer for
details.
To ensure explosion-proof performance, do not damage explosion-proof surface.
Use the provided glove when open up the dome cover, and avoid direct contact with the
dome cover, because the acidic sweat of the fingers may erode the surface coating of
the dome cover.
Ambient temperature: -40°C - +60°C
DO NOT open when an explosive atmosphere is present potential electrostatic charging
hazard-see instructions.
When assembly and operation, the operator must follow the requirements of the IEC
60079-14: latest version Explosive atmospheres- Part 14: Electrical installations design,
selection and erection, beside of the manufacturer's operating instructions or its
National equivalent.
Maintenance shall comply with IEC 60079-17.
Repair and overhaul shall comply with IEC 60079-19: latest version or its National
equivalent.
Cleaning
Please use a soft and dry cloth to clean the inner and outer surfaces. Do not use alkaline
detergents.
Keep the surface clean and prevent dust accumulation. DO NOT clean the surface by
compressed air duster.
Using Environment
When any laser equipment is in use, make sure that the device lens is not exposed to
the laser beam, or it may burn out.
Do not aim the lens at the sun or any other bright light.
To avoid heat accumulation, good ventilation is required for a proper operating
environment.
DO NOT expose the device to extremely hot (the operating temperature shall be -40°C
to 60°C (-40°F to 140°F)), cold, dusty, corrosive, saline-alkali, or damp environments. For
temperature and humidity requirements, see device specification.
DO NOT expose the device to high electromagnetic radiation.
To avoid fire danger caused by electrostatic charge, never touch or wipe the speed dome
in explosive environment. Perform the wiping and replacing accessories only under
non-explosive environment with the provided glove.
Emergency
If smoke, odor, or noise arises from the device, immediately turn off the power, unplug
the power cable, and contact the service center.
Time Synchronization
Set up device time manually for the first time access if the local time is not synchronized
with that of the network. Visit the device via web browser/client software and go to
time settings interface.
vii
Advertisement
Table of Contents
