Table of Contents
Advertisement
Ex
The equipment has been designed, when required, modified for connection to an IT
power distribution system.
Fire Prevention
No naked flame sources, such as lighted candles, should be placed on the equipment.
The serial port of the equipment is used for debugging only.
Hot Surface
CAUTION: Hot parts! Burned fingers when handling the parts.
This sticker is to indicate that the marked item can be hot and should
not be touched without taking care. Wait one-half hour after switching
off before handling parts.
The device with this sticker is intended for installation in a restricted access location.
Access can only be gained by service persons or by users who have been instructed
about the reasons for the restrictions applied to the location and about any precautions
that shall be taken.
Installation
Install the equipment according to the instructions in this manual.
To prevent injury, this equipment must be securely attached to the wall in accordance
with the installation instructions.
Be sure that there is enough space to install the device and accessories.
Make sure that the wall is strong enough to withstand at least 8 times the weight of the
device and the mount.
Make sure that the power has been disconnected before you wire, install, or
disassemble the device.
Transportation
Keep the device in original or similar packaging while transporting it.
Do not drop the product or subject it to physical shock.
Power Supply
The power source should meet limited power source or PS2 requirements according to
IEC 60950-1 or IEC 62368-1 standard.
Refer to the device label for the standard power supply. Please make sure your power
supply matches with your device.
Use a power adapter provided by qualified manufacturers. It is recommended to provide
an independent power adapter for each device as adapter overload may cause
over-heating or a fire hazard.
System Security
Please understand that you have the responsibility to configure all the passwords and
other security settings about the device, and keep your user name and password.
Maintenance
If the product does not work properly, please contact your dealer or the nearest service
center. We shall not assume any responsibility for problems caused by unauthorized
repair or maintenance.
Explosion-proof Dome·Quick Start Guide
vi
Advertisement
Table of Contents
