Table of Contents
Advertisement
Ex
2. Check if the device performs power-up action. If not, contact the technical support.
Normally, the power-up action should include the device movement of
automatically panning and tilting.
3. Check if the image can be displayed normally. If not, contact the technical support.
4. Start the installation after making sure the device works properly.
Note:
If the speed dome cannot be powered up, check the cable connection carefully.
2.2 Cable Description and Routing
Power Cord
RS-485 Cable
Alarm Cable
Audio Cable
Network Cable
Notes:
The cables vary depending on different speed dome models.
The three cables of the power cord should be connected to corresponding wires.
The red cable should be connected to live wire. The black cable should be
connected to neutral wire. The yellow/green cable must be connected to the
ground.
To avoid transmitting interference, route power cables separately.
Explosion-proof Dome·Quick Start Guide
Figure 2-1 Cable Description
4
Advertisement
Table of Contents
