Main Feature; Set Up Instruction; Power On And Turn On / Off - netvox R718J2 User Manual

Wireless 2-input dry contact interface

Hide thumbs Also See for R718J2:

Table of Contents

3. Main Feature

⚫ Apply SX1276 wireless communication module

⚫ 2 ER14505 lithium batteries (3.6V / section) parallel power supply

⚫ Dry contact detection

⚫ The base is attached with a magnet that can be attached to a ferromagnetic material object

⚫ Protection class IP67

⚫ Compatible with LoRaWAN

Class A

⚫ Frequency hopping spread spectrum

⚫ Configuration parameters can be configured via a third-party software platform, data can be read and alerts can be set via SMS

text and email (optional)

⚫ Applicable to third-party platforms: Actility/ThingPark, TTN, MyDevices/Cayenne

⚫ Low power consumption and long battery life

(1) Power on: Insert batteries: open the battery cover; insert two sections of 3.6V ER14505 AA batteries and close the battery

cover.

(2) Turn on: If the device had never joined in any network or at factory setting mode, after powering on, the device is at off mode

by default setting. Press and hold function key for 3 seconds till the green indicator flashes once and release to turn on device.

(3) Turn off: Press and hold function key for 5 seconds till the green indicator flashes quickly and release. The green indicator

will flash 20 times to show that the device is turned off.

Note:

1. The interval between shutting down twice or power off/on is suggested to be about 10 seconds to avoid the interference of

capacitor inductance and other energy storage components.

2. Do not press function key and insert batteries in the same time, otherwise, it will enter engineer testing mode.

3. Turn off operation is same with "Restore to Factory Setting" operation.

4. Each time the battery is removed, it will be installed in the default "turn off" state, and users can turn on.

Table of Contents