Table of Contents
Advertisement
The workpiece coordinate system interface is shown as below:
Coordinate system auxiliary parameter setting interface
The auxiliary parameters for workpiece coordinate system, including offset and tool setting parameters of
tool setting gauge
To enter coordinate system auxiliary parameter setting interface:
[COORD]
[set]
The detailed auxiliary parameters are described in the table below:
1
2
3
4
5
6
7
8
9
10
11
Workpiece Coordinate System Setting Interface
X coord offset
Y coord offset
Z coord offset
A coord offset
X knife tool coord
Y knife tool coord
Z knife tool coord
A knife tool coord
Auto tool choice
Tool checking elevel
Tool checking run after T code
Advertisement
Table of Contents
