Table of Contents
Advertisement
Move the tool to make its side blade touch side A surface of the workpiece, and press [EOB] to record boundary point
1;
Move the tool to make its side blade touch side B surface of the workpiece, and press [EOB] to record boundary point
2;
Press [EOB] to calculate the coordinates of center point;
If all are ok , press [EOB] again to return the result to specified coordinate system.
Square centered
Select the edit mode;
Select MPG or Jogl mode;
Press [Coord] to enter coordinate system setting interface;
Press the left/right arrow to move the cursor to select coordinate system;
Press [HALVE] to enter centered interface;
Move the tool to make its side blade touch side A surface of the workpiece, and press [EOB] to record boundary point
1;
Move the tool to make its side blade touch side B surface of the workpiece, and press [EOB] to record boundary point
2;
Record boundary point 3.4 in the same method;
Press [EOB] after recording all boundary points to calculate the coordinates of center point;
If all are ok, press [EOB] again to return the result to specified coordinate system.
Plane circle (XY plane) centered
Circle centered has two modes, which are three points and two points with specified radius; If the user
only types two coordinates in the option of workpiece boundary point and specifies one value for R, the system
will determine the circle center with two points and radius automatically; if the user types coordinates of three
points in the option of workpiece boundary point, the system will determine the circle center with three points
and shield R.
The centered step of three points arc follows:
Advertisement
Table of Contents
