Table of Contents
Advertisement
Relative position
In Jog mode, reset current coordinates to check the relative motion distance of any displacement, and thus
it is called as relative position.
This interface is usually used for early tool setting. Considering that some operators have been used to
manual calculation, this function is preserved. With the more and more powerful of automatic centered
function, it is used less.
The operation as follows:
Enter [Pos] interface;
Switch to [Rele] interface;
Then, enter Jog mode;
Press a coordinate axis No., e.g.,
Press Cancel to reset X coordinate to 0;
The relative position interface as follows:
General (All) coordinates
The interface displayed by absolute coordinates and machine coordinate
General position interface is shown as below:
, and the X coordinate flashes;
Relative Position Interface
Advertisement
Table of Contents
