Note
•
Be sure to press the button sequence within thirty seconds after the sound signal
for security reasons. Up to 2 s intervals are allowed between the presses.
Switching between Static and Dynamic IP Address
®
•
Connect 2N
IP Safety to the power supply (or, disconnect and reconnect it if already
connected).
•
Wait for the first sound signal
•
Press the quick dial button on the main unit 15 times.
•
Network parameter reset and DHCP switch are signaled by the
•
For devices with FW versions 2.33 and lower, wait until the device is automatically
restarted.
•
After restart, the static IP address mode is switched into the dynamic IP address and
vice versa.
•
Simultaneously, all the System / Network parameters are reset to default values. This is
useful where it is impossible to connect to the device due to wrong VPN configuration, for
example.
Installation manual 2N® IP Safety
.
sound.
69 / 82