2N IP Safety Installation Manual page 49

Static IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DHCP OFF):
• Press and hold the RESET button.
• Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
• Wait until the red LED goes off and the acoustic signal
another 3 s).
• Release the RESET button.
The following network parameters will be set after restart:
• IP address: 192.168.1.100
• Network mask: 255.255.255.0
• Default gateway: 192.168.1.1
Dynamic IP Address Setting
Follow the instructions below to switch on the Dynamic IP address mode (DCHP ON):
• Press and hold the RESET button.
• Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
• Wait until the red LED goes off and the acoustic signal
another 3 s).
• Wait until the green LED goes off and the red LED goes on again and the acoustic signal
can be heard (approx. for another 3 s).
• Release the RESET button.
Installation manual 2N® IP Safety
can be heard (approx. for
can be heard (approx. for
49 / 82