Leica Viva GNSS Getting Started Manual page 37

Wizards
Taking an image
using the instru-
ments camera
Viva GNSS, SmartWorx and Principles
The wizards following are available to make your daily work easier. Each of them lead
you through a series of steps, performing tasks in a specific sequence. For detailed
descriptions of the wizards, please refer to the Leica Viva/Nova Series Technical Refer-
ence Manual.
Wizard
SmartWorx StartUp Wizard
RTK rover wizard
GS connection wizard
TPS connect wizard
Internet wizard
CS connection wizard
Working style wizard
Check & Adjust Wizard
Step Description
1.
Tap the camera icon
Camera screen.

For a field controller, which is configured to use an instrument with
a camera, the Capture Image with Camera screen has two pages (TS
camera and CS camera). Select which camera to use by clicking the
corresponding page or using Page to toggle between both pages.
2. Aim the camera to the desired target.
3. Check the view at the display.
4. Press OK or click Cpture to take the picture.

Cpture changes to Store.
5.
The image can be overlaid with a sketch. Click the
activate sketching. The
to control the line weight, style and colour of any lines you "sketch" on top
of your image. The image cannot be moved.
6. Press Store to save the image. A confirmation window opens. The image can
be linked to a point, line or area.
7. • Press Last to link the image with the last stored point and save it.
• Press Select to link the image with any point, line or area of the current
working job and save it.
• Press No to save the image in the current working job without linking it
to a point, line or area.

After the image has been stored you automatically return to the
Capture Image with Camera screen.
Description
Define the behaviour of your instrument for a
general start-up.
Set up your real-time rover.
Connect your CS field controller with your GS instru-
ment.
Connect your CS field controller with your TPS
instrument.
Connect your CS field controller with the Internet.
Connect your CS field controller with your TPS
instrument.
Configure the parameters and functions of Smart-
Worx so that it suits to your preferred method of
working and save the settings in a working style.
For TPS. Check and adjust the instrument in the field
by running through specific measurement proce-
dures.
in the icon bar to access the Capture Image with
icon is displayed. Additional icons are displayed
icon in the toolbar to
37