Removing And Installing The Control Motor Of Central Flap V70 - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
– Guide the holder with control motor in such a way that the lever
-2- grips into the control for the control motor -1-.
– Press the control motor fully into the housing and screw on.
– Insert plug connection, switch on ignition and check operation
of the control motor by pressing the re-circulating air button.
Note
It must be possible to smoothly adjust the fresh air flap and re-
♦
circulating air flap up to the stop.
If there are functional problems abort test immediately and re‐
♦
peat installation.
If the control motor was replaced, perform a basic setting
♦
⇒ Vehicle diagnostic tester.
11.8 Removing and installing the control mo‐
tor of central flap - V70-
Removing
– Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
– Right-hand drive - removing the heating and air conditioning
unit ⇒ page 66 .
– Press the catch -2- and swivel control motor with holder to the
right until the levers no longer engage in the guiding grooves.
– Pull control motor with holder out of the attachments -3-.
– Unplug connector -1-.
Install
– Mount plug -1-.
– Put holder with control motor into the attachments -5-.
– Insert lever -1- into the guiding groove -2- and lever -3- into
the guiding groove -4- of the control motor.
98