Plug Connections At The Heater Control; Removing And Installing Flex Shafts - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
To remove the plastic part, press the flex shafts -arrow- and pull
out of the heater control -1-.
– Slightly press together the catches in the corners and push out
the heater control.
– Disconnect plug.
Installation is performed in the reverse order, pay attention to the
following points:
Note
The flex shafts can only be installed in one way on the heater
control see ⇒ page 13
3.2

Plug connections at the heater control

Special tools and workshop equipment required
♦ Test box - V.A.G 1598/47-
Layout of the individual pins on the multi-pin plug connections A,
B and C on the rear side of the heater control
You can find the connection layout of individual pins in the con‐
nectors in the ⇒ Current flow diagrams, Electrical fault finding and
Fitting locations depending on the current model year and equip‐
ment.
3.3

Removing and installing flex shafts

• Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
Note
The attachment of the flex shaft for the positioning unit of the
temperature flap is the same as the attachment of the flex shaft
for the positioning unit of the air distribution flaps.
Removing
– Press plastic part of the flex shaft -2- in
-the direction of arrow- and pull out of the heater control -1-.
12
Rep. gr.80 - Heating