Removing And Installing The Control Motor For Air Distribution Flaps - Skoda Citigo 2012 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
Heating, Air conditioning - Edition 06.2013
– Push slides -1- fully in -arrows-.
– Take filter cover -3- down and off.
– Pull dust and pollen filter -2- down and out by the tab.
Install
Installation is carried out in the reverse order. Pay attention to the
following:
♦ Before installing check the fitting position of the filter insert.
The top and bottom fin of the filter insert must be in the frame.
♦ The 2 arrows on the frame and filter insert point to the flow
direction.
♦ The frame grid must point to the distributor housing.
♦ The filter cover -3- must be correctly positioned in the housing
and the slides -1- must be pushed fully outwards up to the stop.
4.4 Removing and installing the control mo‐
tor for air distribution flaps
Removing
Right-hand drive:
– Remove heater unit
Left-hand drive:
– Remove the centre console ⇒ Body Work; Rep. gr. 68 .
– Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
– Remove right footwell vent (tightening torque: 1.5 Nm).
– Remove the intermediate piece for the defroster duct (2 se‐
curing pins) and intermediate piece for dash panel vents (2
retaining clips).
All vehicles:
– Release screw -1-.
– Release catches -2- and swivel out the control unit from the
housing in the -direction of the arrow-.
Install
18
Rep. gr.80 - Heating
⇒ page 22 .