Removing And Installing The Ac Compressor From Holder; Check Valve For Condensation Water Drain - Skoda Citigo 2012 Workshop Manual

– Drain the refrigerant circuit with the aid of the A/C service sta‐
tion.
1 - Expansion valve
♦ removing and installing
2 - O-ring 10.80 mm; 1.82 mm
♦ replace
3 - Connection fittings for pressure line
♦ Torsion stop with sleeve
4 - O-ring 14.30 mm; 2.40 mm
♦ replace
5 - 10 Nm
6 - Connection fittings for suction line
♦ Torsion stop with sleeve
Note
After disconnecting, shut off the refrigerant lines and the expan‐
sion valve connections with suitable caps to protect them from the
penetration of ambient humidity.
5.6 Removing and installing the AC com‐
pressor from holder
1 - Support
♦ engine specific - different versions
2 - 45 Nm
3 - AC compressor
♦ removing and installing
4 - Combination screws
♦ M8 = 25 Nm
♦ M10 = 45 Nm
5 - Dowel sleeves for AC compressor
♦ must be fitted in the holder -1- or in the AC compressor -3-
Note
If the refrigerant line was not separated, the AC compressor must
be secured to the side in such a way that the hoses are not ex‐
cessively strained.
5.7 Check valve for condensation water
drain
Perform the inspection if the floor covering under the heating and
air conditioning unit becomes damp when the air conditioning is
on.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤
⇒ page 50
⇒ page 51
Heating, Air conditioning - Edition 06.2013
5. Air conditioning system - engine compartment
47