Rack Latches Replacement; Remove The Rack Latches - Lenovo ThinkSystem SR150 Maintenance Manual

Figure 64. Closing the processor retainer
After you install the processor, complete the following steps:
1. Reinstall the heat sink (see
2. Install the top cover onto the server (see
3. Install the server into the rack if necessary.
4. Reconnect power cords and all external cables.

Rack latches replacement

Use the following information to remove and install the rack latches.

Remove the rack latches

Use this information to remove the rack latches.
Before you remove the rack latches, complete the following steps:
1. Read "Safety" on page iii
2. Turn off the server. Disconnect the power cords and all external cables (see
page 10).
3. If server is installed in a rack, remove the server from the rack.
4. If security bezel is installed, remove it first (see
To remove the rack latches, complete the following steps:
Note: Both rack latches are removed and installed in a similar method.
Step 1. Use a flat-blade screwdriver to slide down the ID label plate on the right rack latch and place it in a
safe place.
Figure 65. ID label removal
"Install the heat sink" on page
"Install the top cover" on page
and "Installation Guidelines" on page 31
"Remove the security bezel" on page
57).
87).
to ensure that you work safely.
"Power off the server" on
.
Chapter 3 Hardware replacement procedures
74).
71