Install A Simple-Swap Disk Drive - Lenovo ThinkSystem SR150 Maintenance Manual

Figure 33. Simple-swap disk drive removal
Step 1. Use a flat-blade screwdriver to rotate the drive lock clockwise.
Step 2. Make sure the drive handle is released after unlocking.
Step 3. Grab the handle to pull the drive out of the drive bay.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Install a simple-swap disk drive

Use this information to install a simple-swap disk drive.
Before you install a simple-swap disk drive:
1. Read "Safety" on page iii
2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
3. Identify the drive bay in which you plan to install the simple-swap drive.
Notes:
• When SATA drives are installed and connected to SATA connectors 4-7 on system board (without a RAID
adapter installed), the drive number will be reported by RAID utility as drives 4, 5, 6, and 7 (different from
drive bay number)
• When SAS or SATA drives are installed and connected to RAID adapter, the drive number will be 0, 1, 2,
and 3 (same as drive bay number)
• Drive bay 2 and 3 are not available when the two-drive backplate is installed.
To install a simple-swap disk drive, complete the following steps:
Note: When the fourth SATA drive is installed, the M.2 drive is not supported.
ThinkSystem SR150 Maintenance Manual
44
and "Installation Guidelines" on page 31 to ensure that you work safely.