Air Baffle Replacement; Remove The Air Baffle - Lenovo ThinkSystem SR150 Maintenance Manual

Figure 24. Adapter installation
Step 1. Remove the fillers on the rear side of the riser cage.
Step 2. Align and insert an adapter into the slot on the riser card. Make sure you install the adapter into the
right slot.
Notes:
• For the detail connectors on the PCIe riser card, see
• Install one adapter at a time, do not insert two adapters to the riser card at the same time.
After you install an adapter, complete the following steps:
1. Reconnect the cables.
2. Reinstall the PCIe riser assembly (see
3. Install the top cover onto the server (see
4. Install the server into the rack if necessary.
5. Reconnect power cords and all external cables.
6. If necessary, configure the RAID array using the Setup utility configuration.

Air baffle replacement

Use the following information to remove and install the air baffle.

Remove the air baffle

Use this information to remove the air baffle.
Before you remove the air baffle, complete the following steps:
1. Read "Safety" on page iii
2. Turn off the server. Disconnect the power cords and all external cables (see
page 10).
3. If server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see
To remove the air baffle, complete the following steps:
"Install the PCIe riser assembly" on page
"Install the top cover" on page
and "Installation Guidelines" on page 31
"Remove the top cover" on page
"PCIe riser assembly" on page
63).
87).
to ensure that you work safely.
"Power off the server" on
86).
.
Chapter 3 Hardware replacement procedures
20.
35