Lenovo ThinkSystem SR150 Maintenance Manual page 21

Figure 5. Front view
Table 3. Components on the server front view
VGA connector
1
USB 2.0 connector (with Lenovo XClarity Controller)
2
USB 3.1 Gen1 connector
3
1 VGA connector:
Connect a monitor to this connector.
Notes:
• When the front VGA connector is in use, the rear VGA connector will be disabled.
• The maximum video resolution is 1600x1200 at 75 Hz.
2 3 USB connectors:
Connect a USB device, such as a USB mouse, keyboard, or other device, to any of these connectors.
Following are detailed descriptions of each connector:
• USB 1: USB 2.0 with Lenovo XClarity Controller management
• USB 2: USB 3.1 Gen1
4 Front operator panel
Front operator panel contains several LED and buttons, see
information.
5 Simple-swap drives:
Install drives into these bays. See
Notes:
• When SATA drives are installed and connected to SATA connectors 4-7 on system board (without a RAID
adapter installed), the drive number will be reported by RAID utility as drives 4, 5, 6, and 7 (different from
drive bay number)
• When SAS or SATA drives are installed and connected to RAID adapter, the drive number will be 0, 1, 2,
and 3 (same as drive bay number)
• Drive bay 2 and 3 are not available when the two-drive backplate is installed.
6 Rack latches:
4
5
SATA port 4-7 on system board, see
connectors" on page
6
"Install a simple-swap disk drive" on page 44
Front operator panel
Simple-swap drive bays (numbering 0-3, matching
16)
Rack latches
"Front operator panel" on page 14
for more details.
Chapter 2
"System-board
for more
.
Server components
13