Table of Contents
Advertisement
SETTING-UP THE H-KING MX2 EXTREME 3D:
Travel Settings:
Each flight control must be set to its physical limits. This means as far as it will go, but no farther
than it has to. You set this by selecting the servo, fully deflect the surface with the transmitter,
then increase (or occasionally decrease) the percentage to where the flight surface will not
travel any further. Then simply back off a click or two and you are done. Then, deflect it in the
opposite direction and repeat the process. This must always be done for rudder, ailerons, flaps
and elevators. Your travel/end point settings must be above 100% to achieve full performance
from each servo.
Rates and Exponential
All rates at 100% for full 3D flying. Put the stick at one third and set to where when you switch
between rates the surface hardly changes. Obviously at the end points it is an enormous difference.
Our Recommended expo settings for low rates is in the 20% range for an aerobatic plane, and expo
in the 60% to 70% range for high rates for 3D.
C of G Position:
95mm
to
100mm
Happy Flying!
9
Advertisement
Table of Contents
