Rudder And Elevator Pushrod Installation - H-KING MX2 Extreme 4S EP0 Instruction Manual

Rudder installation.
Install one of the supplied M3 x 35mm bolts through one of the wheel spat outer halves and add a
plywood washer and wheel as shown. Then slide on the inner half of the wheel spat, pass the
remaining part of the bolt through the hole in the carbon landing gear, then secure the spat/wheel
assembly in place by using the supplied M3 nut. Apply some thread locker to the thread to prevent any
loosening in flight. Repeat this process for the other spat and wheel. Secure the carbon fiber landing
gear onto the landing gear mount on the underside of the fuselage using the supplied M4 x 30mm
screws as shown.

Rudder and elevator pushrod installation.

Before you install the pushrod to the servo, ensure the servo control arm is perpendicular to the servo
case. Install the end of the pushrod with the Z bend on into the outer most hole on the servo control
arm. Then connect the ball socket end onto the rudder surface control horn, secure it with the supplied
screw and retaining nut. Apply some thread locker to keep it secure.
Repeat the above steps for the elevator control linkage installation.
6