Table of Contents
Advertisement
Then tape the other end to the rear part of the wing saddle. Once you are satisfied with the overall
fit and placement of the PVC windshield, secure it in place using the supplied M1.5x6 mm
self-tapping screws.
ELEVATOR AND RUDDER SERVO INSTALLATION:
Before installing the elevator servo, feed the servo lead through the plastic tube from the tail
servo mount at the rear of the fuselage to the main radio compartment. A couple of standard
servo extension leads or a single longer one are required for this setup. Using a medium CA glue,
glue the supplied control surface horn to the elevator. This kit includes a couple of servo
mounting spacers (F26), these are required if using the larger 5 or 6g servos which need a bit
more room in the tight servo compartment at the tail. However, if you are using smaller size
servos, then these spacers should not be required.
9
Advertisement
Table of Contents
