Table of Contents
Advertisement
SERVICE
INTERVAL
Flails
Before each use
While operating
After each use
Gearbox
Before each use
50 hours of operation
100 operating hours or a
minimum of once a year
Rotor
After 20 hours of operation
Belts
Before each use
The equipment
After each use
FAULT
The flail mower cuts unevenly
or badly
The cutting sound changes
Vibrations
RECYCLING
For scrapping, the equipment/product must be dismantled and transported
to a recycling station designated by your local authority. Any liquids should
be collected and transported to a recycling station designated by your local
authority. Contact your local authority for further information.
MEASURE
Replace all defective flails. Sharp blades give better results.
When replacing blades, tighten bolts fully.
Listen out for noises
Checking
Check the level of the Oil type:
Gearbox oil 80W-90 Quantity: 0.7 l
First oil change
Oil change
Lubrication
Belt tensioning. The belt should move 20 mm under pressure.
Wash off earth and grass with water.
MEASURE
Check that all flails are intact and firmly in position.
Adjust the support roller and check that is in the correct
position.
Check the drive belts and tighten if necessary.
Check the roller.
Check the tension of the drive belts.
Check the flails.
Check the flails.
Table of Contents →
17
Advertisement
Table of Contents
