Table of Contents
Advertisement
Slipping and fall accidents
Accidents involving slipping and falling are often a result of:
• Slippery conditions
• Uneven steps and work platforms.
The risk of slipping and falling can be reduced considerably by exercising good judgement.
All unprotected rotating machine parts are a potential for accidents. Accidents usually occur
when loose-fitting clothing or long hair is caught and wrapped around rotating parts, such as
PTO shafts or drive shafts on the machine. Ensure that all guards are fitted correctly.
Drive safely on public roads
•
Always follow traffic safety rules on public roads, and following the regulations applying
to driving a tractor with towed equipment on a public road.
•
Check that reflectors, warning signals and/or warning flags indicating protruding equip-
ment are fitted to the machine or tractor. These indicators must be correctly mounted,
and must be visible and easy for drivers of other vehicles to see.
•
Bystanders must not lean against or climb onto the machine during transport or during
work. NEVER allow anyone to travel on the machine!
•
The maximum transport speed must not exceed 20 km/h
MACHINERY/EQUIPMENT CONNECTED TO HYDRAULICS
Be careful when you connect your machine or equipment to a hydraulic hose.
•
Warning of high pressure, risk of penetration injury.
•
Before repairs or maintenance are carried out, the system must be relieved of any remain-
ing pressure.
•
Turn off the tractor and move the hydraulic levers back and forth to release any pressure
that may still be in the oil hoses and pipes before starting any work on them or the hy-
draulic cylinders.
•
Clean the filter in the suction pipe after 10 hours' work.
•
Immediately replace hydraulic hoses if cracks or wear are detected.
•
Do not adjust the valve settings. Incorrect adjustment can result in damage to the ma-
chine and/or injury.
•
The hydraulic system must only be operated using hydraulic oil intended for the purpose.
Check the oil level before you start the machine!
•
When commissioning a new machine, it is recommended that the hydraulic oil is changed
after the first 10 hours of operation, in order to remove any dirt or metal chips which may
have got into the hydraulic system.
12
Pressurised oil and fuel leaks can penetrate skin and cause serious injuries. Do not use your
hands to locate leaks. Use a piece of paper or cardboard to search for leaks.
← Table of Contents
DANGER!
Advertisement
Table of Contents
