Table of Contents
Advertisement
MAINTENANCE AND SERVICE
Make sure the product is stable and not likely to tip over during maintenance and service.
Replace damaged and worn parts immediately to reduce the risk of damage. Perform main-
tenance, servicing and inspections as recommended. Use only parts with equivalent perfor-
mance to reduce the risk of damage and failure. All repairs and connections with electricity
must be performed by an authorized person. Always follow the safety regulations according
to maintenance schedule. Especially pay attention to the safety of knives, danger occur if they
come loose during operation.
•
Regularly check the condition of the product before the failure is a fact. Discovered
cracks, twisting, bending, glitches or fatigue stop work and rectify the fault. Worn parts
should be replaced.
•
Re-tighten all nuts and bolts after a few hours of driving.
•
Disconnect the equipment from the tractor when the fault remedied.
•
Check all nuts and bolts are tightened after performning maintenance and service.Al-
ways test the machine before using it.
•
Lubricate all lubrication points regularly.
For spare parts: Contact Kellfri Service
RECYCLING
Disposal of the product, disassemble and transport to the municipality's recycling station.
Contact your local authority for further information.
ASSEMBLY INSTRUCTIONS
Apply grease on the surfaces
that is assembled together to
decrease wear, prevent corrosion
and simplify future service.
SPARE PARTS
1. Blade
2. Pin wheel bracket
3. Wheel Bracket
4. Wheel 4.80 / 4.00-8
5. Pin - locking angle 34x78
6. Locking pin - Boom
7. Bolt M16x75
6
8. Suspension
9. Pin - boom 39x325
10. Boom
11. Rotation plate
12. Adjustment Rod - wheel
13. Steel blade
14. Bolt M16x40
15. Pin to the tower
16. Bolt 10 x 20
17. Washer - tower
18. Joint pin 25x184 + M20 nut
19. Sprint outrigger 16x70
20. Outriggers
21. Locking pin to the tower 27,5x111
22. 3 point linkage
23. Cylinder
24. Hydraulic hose
25. Hook
26. Nut M18
27. Sleeve
Advertisement
Table of Contents
