Table of Contents
Advertisement
MAN – FD320LIFT-LP Ver HD
Installation Instructions
All cabin entertainment equipment, such as the FD320LIFT-LP Ver HD, should be
installed on a non-essential bus and have a dedicated circuit breaker. It is a
requirement that a switch be installed in the cockpit so that the pilot can de-energize
the entertainment system should it become necessary.
Power
This is a 28VDC monitor that requires 5 Amps of power to operate the LCD, and 3
Amps of power to operate the mechanical lift. It is recommended that the LCD and lift
be powered by two separate circuit breakers.
Adjusting Stowed Position Height
The FD320LIFT-LP Ver HD down limit can be adjusted up to 1-1/2". The unit is pre-
adjusted to the lowest stow position. Access the adjustment bolt through the opening
on the top of the lift as shown below. Using a 3/8" wrench turn the down limit
adjustment bolt clockwise to raise the stowed position (display will stop sooner) or
counter-clockwise to lower the stowed position (display will travel further into cabinet).
The upper limit is factory set at the maximum height. In the event this range interferes
with the headliner or other equipment some adjustment is possible. Contact Flight
Display Systems for additional information.
The FD320LIFT-LP Ver HD can be manually lowered in the event power is lost to the
lift. The unit is supplied with a 3-foot flexible drive shaft and panel mount fitting. Attach
the flexible shaft to the gear box shaft as shown and tighten the 2 set screws. Attach
panel mount fitting at access panel. The display can be raised and lowered with the
supplied ¼" speed handle or other ¼" square drive tool.
All manuals and user guides at all-guides.com
Rev:
Revision Date:
08/27/2012
C
Page 6 of 22
Advertisement
Table of Contents
