Wiring Suggestions; S-Video/Comp And Audio Wiring - Flight Display Systems FD320LIFT-LP Installation And Operation Manual

MAN – FD320LIFT-LP Ver HD
Caution: Limit switches do not function when manually raising or lowering the display.
Be sure not to exceed upper or lower travel limits, this could result in permanent
damage to the FD320LIFT-LP Ver HD.

Wiring Suggestions

All shields should be grounded to the connector at the source, and floating at the
display.
Avoid routing video wiring parallel to:
 AC wiring
 Strobe wiring
 DC motor supply cables
 Inverter cabling
 Or any other potential noise source
S-Video/Composite and Audio Wiring
Recommended cable for s-video/composite and audio purposes is PIC 75 Ohm Coax,
P/N V75268. This is a lightweight, flexible, and low signal loss cable which meets FAA
flammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).
All manuals and user guides at all-guides.com
Rev:
Revision Date:
08/27/2012
C
Page 7 of 22