Command Sets - Flight Display Systems FD320LIFT-LP Installation And Operation Manual

MAN – FD320LIFT-LP Ver HD
Command sets for controlling the monitor:
Below are the command sets to control the power, source selection, and backlight
brightness. The 13 characters below are shown in hexadecimal. The communication
system must be set up for 19200 Baud, no parity, 8 bits of data, and 1 stop bit.
POWER OFF 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
POWER ON 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
VGA 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
Composite 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
S-Video 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
HDMI 1 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
HDMI 2 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
0% 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
Increment
0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
by 1%
100% 0xBE 0xEF 0x02 0x06 0x00 0x1F 0xD1 0x26 0x00
Notes
Notes:
1. The first nine characters will remain the same for any command.
2. For connecting multiple monitors to one controller; the number can be set to 0x00 to
control all monitors at once, 0x01 to control monitor number 1, 0x02 monitor number 2,
and so on until 0x63 for monitor number 99.
3. The number will change depending on command.
4. Identifier for the group of commands.
5. All commands need to end with a Carriage Return
The RS-485 connector carries information between the Infrared received and the LCD
controller board. Any connections to the RS-485 bus must be tolerant to the existing
control signals. Devices connected to the RS-485 Bus should not send traffic that
interferes with the existing RS-485 messages.
All manuals and user guides at all-guides.com
POWER
SOURCE SELECTION
BACKLIGHT
1
Rev:
Revision Date:
08/27/2012
C
Page 14 of 22
0x00 0x01 0x01
0x00 0x00 0x01
0x00 0x00 0x02
0x00 0x01 0x02
0x00 0x02 0x02
0x00 0x06 0x02
0x00 0x07 0x02
0x00 0x00 0x03
Increment
0x00 0x03
by 0x01
0x00 0x64 0x03
2 3 4
0x00 CR
0x00 CR
0x00 CR
0x00 CR
0x00 CR
0x00 CR
0x00 CR
0x00 CR
0x00 CR
0x00 CR
5