Table of Contents
Advertisement
MAN – FD420CV VER HD
Specifications
Display Type
Display Color
Screen Resolution
Brightness
Dimensions
Display Size
Weight
Power
PC & Video Input
Video Type Supported
Screen Control
Viewing Angle
Materials
DO-160 Testing
Remote Control
Pixel Pitch
Installation Instructions
All cabin entertainment equipment, such as the FD420CV VER HD, should be installed on
a non-essential bus and have a dedicated circuit breaker. It is a requirement that a switch
be installed in the cockpit so that the pilot can de-energize the entertainment system
should it become necessary.
There are four – ¼ - 20 UNC mounting holes in the rear.
Mounting against the bulkhead or on a bracket: The unit can be mounted internal,
external, or partially internal to the bulkhead. It is recommended that you leave about ¼
inch of space around the rear, top and bottom of the display for the exhaust fan to have
circulating air. When mounting from inside the bulkhead it is possible to have only the
LCD visible to the cabin. The unit will come on automatically upon power application and if
using an external video source selection box the IR is not needed. If you are using the IR
to change the video source selection then you need to have the IR LED visible to the
cabin.
Power
This is a 28VDC monitor that requires 10.2 Amps of power to operate. The unit turns on
automatically upon power application.
Rev:
42" TFT Color LCD
1.06 Billion Colors (10 Bit)
1920x1080 WUXGA
500 cd/m
2
40"(W) x 24.8"(H) x 2.55"(D)
36.7"(W) x 20.7"(H)
43 lbs
28VDC @ 10.2 AMPS
VGA (High Density DB-15 Connector),
S-Video, Composite, HDMI (2)
NTSC/PAL
On Screen Display Menu
178° on Both Axis
Aluminum
Section 21, Category B
IR, included
0.4845mm x 0.4845mm
Revision Date:
05/23/2014
M
Page 5 of 21
Advertisement
Table of Contents
