Configuring The Ip Address Via The Front Panel - TANDBERG ENTRYPOINT Administrator's Manual

Tandberg user guide network device entrypoint
Table of Contents

Advertisement

Configuring the IP Address via the Front Panel

About Entrypoint Configuration
The Entrypoint requires some basic
configurations before it can be used. It is
necessary to configure the IP-address and
to create the dial-in and dial-out services to
program the ISDN-PRI Line numbers.
Configuring via the Front Panel
The LCD panel makes it possible to configure
and check the IP settings as well as to reboot
the system. The front panel LCD menu items
are as follows:
IP Settings
Menu Hierarchy
IP Address
IP Netmask
Main Menu
IP Default GW
IP Settings
IP Information
IP Information
Commands
IP Address
Commands
Reboot
Configuration via RS 232
As an alternative to the configuration via the LCD
panel you may use RS 232 to configure and the
system. This is treated on the previous page.
Switching On the Unit
Power switch
Table of
Trademarks &
Patents &
Contents
Copyright
Disclaimers
D 14050.04
10.2007
Switch on and press any key to produce
the
Main
Menu. Use
UP/DOWN
to navigate
to the
IP
Settings, if needed.
In addition to configure the IP address you
must also configure the default-gateway,
netmask and set IP assignment to static.
Use
ENTER
to enter
Digit Altering
Mode.
When finished editing use
ESC
to go to
the
Confirm change
menu.
DHCP assigned IP-addresses are supported by the TANDBERG Entrypoint (factory default).
UP key
ENTER key
DOWN key
ESC key
Safety/
To Get You
To Get You
Using the
Environmental
Up and Going
up and Going
Entrypoint
Configuring the IP Address via the Front Panel
Press
ENTER
to access the
IP Settings
submenu.
Press
ENTER
again to produce the
cursor.
Use
UP/DOWN
to alter the digit value.
Use the
UP/DOWN
key to select
no
and
ENTER
to confirm.
Viewing the
Configuring
Maintenance
System Status
the Entrypoint
15
TANDBERG
Use the
UP/DOWN
keys to select
Address.
Use
UP/DOWN
keys to navigate
between the digits of the number.
Press
ENTER
as many times as needed
to move to the next digit to be altered
and alter this digit.
Use
ESC
key to navigate back to the
yes
or
main menu.
Dial Plan
Services
& Upgrade
Examples
ENTRYPOINT
USER GUIDE
IP
Contact
Information

Advertisement

Table of Contents
loading

Table of Contents