Table of Contents
Advertisement
The Front and Rear Panels
About the Rear Panel LED Operation
•
Green: Normal operation.
•
Red Alarm
or Loss of Signal (LoS) indicates that there is no
signal and thus no framing information received. A defective
or unplugged PRI cable will produce the same effect.
•
Yellow Alarm
or
Remote Alarm Indicator
the Entrypoint is receiving framing info, but in this framing
info the other side tells the Entrypoint that it is not reading
the Gateway's transmitted framing information. Typically, this
may be a broken connector in the transmit (TX) part of the
PRI cable. This could also indicate weak or noisy signal in the
transmit (TX) part of the PRI cable.
•
Blue Alarm
indicates that the received frames are not
synchronized properly.
•
No LED's
illuminate, indicates that layer one framing is
working (right protocol like for example EURO ISDN selected),
however, there is a problem at layer 2 caused by for example
a CRC4 configuration mismatch.
Entrypoint Start-up
To start the Entrypoint, simply connect the power cable, and
press the power switch button at the back side to position 1.
On the front panel of the system the power indicator LED,
marked Pwr, will turn GREEN.
Table of
Trademarks &
Patents &
Contents
Copyright
Disclaimers
D 14050.04
10.2007
(RAI) means that
Power switch
Safety/
To Get You
To Get You
Environmental
up and Going
Up and Going
Connectors, Switches, Display, and Buttons
LCD panel
Control buttons
RS 232 interface
VGA connector
1 PRI interface
depending on the configuration ordered,.
Using the
Viewing the
Configuring
Entrypoint
System Status
the Entrypoint
13
USB interface
LAN interface
or
4 BRI interfaces
Power connector
Maintenance
Services
& Upgrade
TANDBERG
ENTRYPOINT
USER GUIDE
Power On/Off
indicator
Power switch
Dial Plan
Contact
Examples
Information
Advertisement
Table of Contents
