Table of Contents
Advertisement
By default the ECS0016 LAN port auto detects the Ethernet connection
speed. However you can use the Media menu to lock the Ethernet to 10
Mb/s or 100Mb/s and to Full Duplex (FD) or Half Duplex (HD).
Please note: If you have changed the ECS0016 IP address, you may
need to reconfigure your PC/workstation so it has an IP address that is
in the same network range as this new address (as detailed in an earlier
note in this chapter).
Apply. You will need to reconnect the browser on the PC /
4.
Click
workstation that is connected to the ECS0016, by entering http://new
IP address .
System Services
The Administrator can access and configure the ECS0016 gateway using
a range of access protocols. The factory default enables HTTPS and SSH
access and disables HTTP and Telnet. The Administrator can simply dis-
able any of the services, or enable others.
Select the System: Services option then select /deselect for the service
to be enabled /disabled. The following access protocol options are avail-
able:
Instruction Manual
8
Advertisement
Table of Contents
