Fronius Selectiva 4.0 2100 Operating Instructions Manual page 47

Charge 50 %
Charge 80 %
Charge Finish
Main Charge Finished
- Signal when main charging phase is finished
Charge not complete
- Signal if the battery is prematurely disconnected from the battery charger
- Can be set from 1 to 10 s
Charge OK
- Battery is being charged or is already fully charged
Cumulative Error
- Signal in the event of an error
- A power failure can be displayed as an error ("ON" setting).
- If the device is in an error state, a freely defined text can be displayed, which
can contain the contact details of the dealer, for example. Detailed informa-
tion can be found in the "USB mode" section.
Cumulative error + warning
- In the same way as the "Cumulative Error" function, the corresponding relay
picks up as soon as an error or warning is present.
Signal Lamp
- It is possible to connect one or more suitable lamps to the relay board to in-
dicate the state of charge or the operating status of the battery charger.
- Detailed information can be found in the "Signal lamp" section of the "Op-
tions" chapter.
Immobiliser
ON
- The relay picks up continuously as soon as the battery charger is connected
to the grid.
Refill Indicator
- Indicates that it is necessary to refill the battery with distilled water.
- Detailed information can be found in the "Additional functions" section of
the "Display" chapter.
Battery Cold
External Air Pump
- The settings are made as explained in section "-> Settings" for "Air Pump".
Detailed information on the relay board can be found in the "Options" chapter.
External lamp
According to the "Charging lights" section of the "Options" chapter, suitable ex-
ternal indicators can be connected in order to visualize the state of charge or the
operating status of the battery charger. The following settings are available:
- Normal (conventional external indicators)
- RGB (LED strips)
47