Rotary Switch - ICP DAS USA I-2533CS Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ

2.4. Rotary Switch

When users would like to update the module's firmware or set the CAN baud rate,
message filter of the I-2533CS series, use the rotary switch on the upper of the power
connector to achieve this purpose. Users can find it on the top of the power connector.
There are 16 sections on the rotary switch. They are described on the following
table.
Switch Value
0
1
2
3
4
5
6
7
8
9
A
B~D
E
F
I-2533CS series CAN to Single Mode Fiber Bridge User Manual (version 1.0.0)
Copyright © 2013 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Figure 2-4 Location of Rotary Switch
Table 2-2 Description of Rotary Switch
Description
Set baud rate to 10 kbps
Set baud rate to 20 kbps
Set baud rate to 50 kbps
Set baud rate to 80 kbps
Set baud rate to 100 kbps
Set baud rate to 125 kbps
Set baud rate to 250 kbps
Set baud rate to 500 kbps
Set baud rate to 800 kbps
Set baud rate to 1 Mbps
Set baud rate to user-defined baud rate which is configured
by I-2533CS utility.
N/A
Set I-2533CS into firmware update mode.
Set I-2533CS into configuration mode.
Page: 12