Download
Share
Print this page
Rosco Dual-Vision XC4 Installation Manual
  1. Manuals
  2. Brands
  3. Rosco Manuals
  4. Digital Camera
  5. Dual-Vision XC4
  6. Installation manual

Rosco Dual-Vision XC4 Installation Manual

Hide thumbs Also See for Dual-Vision XC4:

Advertisement

Quick Links

Download this manual
Setra Coach Bus Installation Guide
This guide will show the proper way to install a Dual-Vision XC4 Camera in a Setra Coach Bus. Please
review the Installation Guidelines for grounding and making connections prior to installing. In this guide
you will find dash removal, wire locations, & mounting locations.
Verify no vehicle service lights are on prior to installation. Contact a Fleet Manager immediately if the
vehicle has any damage
After testing and verifying power wires, disconnect the negative battery terminal to prevent any
accidental shorts or blown fuses
th,
UPDATED October 15
2018
***NEW PART***
***Harness DV457 is needed if trigger wires are being connected***
For Technical Support please contact our support team at:
Techsupport@Roscovision.com
Blue – Extra Installation Parts Needed
Gray – Caution
Purple – New Installation
Red – Warning
Version 4.10.2
Proprietary and Confidential
Setra Coach Bus

Advertisement

loading
Need help?

Need help?

Do you have a question about the Dual-Vision XC4 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Rosco Dual-Vision XC4

Summary of Contents for Rosco Dual-Vision XC4

  • Page 1 Setra Coach Bus Installation Guide This guide will show the proper way to install a Dual-Vision XC4 Camera in a Setra Coach Bus. Please review the Installation Guidelines for grounding and making connections prior to installing. In this guide you will find dash removal, wire locations, & mounting locations.
  • Page 2 Setra Coach Bus Installation Guide Before starting your install, its best to prep the windshield for recorder mounting Giving the VHB tape time to cure before mounting the Recorder will give you a permanent bond and prevent recorders from falling. A- Squeeze to release primer and apply to the windshield B- Apply Primer to the bracket C- Wait for the primer to dry leaving a dull haze on the windshield...
  • Page 3 Setra Coach Bus Installation Guide Installation Layout Before starting your installation, please take note of component mounting locations. Version 4.10.2 Proprietary and Confidential Setra Coach Bus...

  • Page 4: Step 1 - Dash Removal

    Setra Coach Bus Installation Guide Step 1 - Dash Removal: • Start by removing the two T-20 screws on both sides of the center dash Version 4.10.2 Proprietary and Confidential Setra Coach Bus...

  • Page 5: Step 2 - Power Connections

    Setra Coach Bus Installation Guide PLEASE NOTE THESE ARE 24 VOLT CONNECTIONS. ALWAYS CONFIRM CORRECT WIRING WITH YOUR DIGITAL MULTIMETER Step 2 - Power Connections: • Connect ring terminals to the DV’s Constant, Ignition, & Ground wires • Connect the YELLOW IGNITION WIRE to the vehicles top terminal •...
  • Page 6 Setra Coach Bus Installation Guide • Lift the glove box door and remove the two (2) T-20 screws holding the starage compartment (Photo A) • This will give you access to the vehicles fuse box, and mounting locations for the PDC & Modem (Photo B) Version 4.10.2 Proprietary and Confidential...

  • Page 7: Step 3 - Antenna Mounting

    Setra Coach Bus Installation Guide Step 3 - Antenna Mounting: The Manufacture recommends mounting the antenna on the windshield Mount the antenna on the same side of the vehicle as the PDC Notice the angled part of the antenna is on the inside of the vehicle (Photo A & B).
  • Page 8 Setra Coach Bus Installation Guide Antenna Mounting and Cable Routing (Continued): • Using a unibit, carefully drill a hole in the back of the fuse panel (Photo A) • Mount the antenna on the lower windshield & route the antenna cable into the fuse box (Photo Version 4.10.2 Proprietary and Confidential Setra Coach Bus...
  • Page 9 Setra Coach Bus Installation Guide Step 4 - PDC & Modem Connections: • Connect the USB cable from the modem to the PDC and secure with a zip tie (Photo A) • Connect the Antenna cable to the modem (Photo B) •...
  • Page 10 Setra Coach Bus Installation Guide Step 5 - PDC & Modem Mounting: • Secure the PDC & Modem to the factory harness with zip ties (Photo A) • Make sure all connections are made prior to component mounting • Neatly bundle up extra cables and zip tie them behind the fuse panel (Photo B) IT’S IMPORTANT TO NEATLY ZIP TIE WIRES TO A FACTORY BRACKET OR HARNESS TO PREVENT FROM FALLING.
  • Page 11 Setra Coach Bus Installation Guide Step 6 - Camera Mounting and wire Routing: Large truck with split window Small Passenger Vehicle Factory Sensor under Mirror Recorder Mounting Mount away from sun visors & Inside the wiper swipe Emergency Vehicle For small passenger vehicles, mount the Recorder under the rear-view mirror (Photo A). If the vehicle has any factory sensors under the rear-view mirror, mount the Recorder to the right of the mirror, not causing a distraction to the driver (Photo B).
  • Page 12 Setra Coach Bus Installation Guide To verify proper angle & correct mounting, press the driver activity button. Logon to your Rosco account and view activity to confirm proper angle Version 4.10.2 Proprietary and Confidential Setra Coach Bus...