Komatsu 114E-3 Series Shop Manual page 332

SEN00464-01
27. Rocker housing
1) Fit the gasket and install housing assem-
bly (1).
2) Tightening order of bolts
Tighten the bolts in the numerical
q
order shown below: [1]
3
Mounting bolt:
3) Install wiring harness (4).
3
Mounting nut:
1.25 ± 0.25 Nm {0.10 ± 0.03 kgm}
a Locations of wiring harnesses
Color of cable
a Yellow
b Orange
c Red
d Brown
24
→ [7]
24 ± 4 Nm {2.4 ± 0.4 kgm}
Cylinder No.
Right side
1, 3, 5
Left side
Right side
2, 4, 6
Left side
50 Disassembly and assembly
a Install the injector wiring harness ter-
minal (5) in a direction where it will
not interfere with the rocker arm (6)
which moves up and down.
a Take care that wiring harness (4) will
not be pressed strongly against the
inside wall of housing (1), will not
come off guide (e), or will not be bent
sharply.
114E-3 Series