Komatsu 114E-3 Series Shop Manual page 305

50 Disassembly and assembly
2) Remove rear oil seal (2).
38. Gear housing
Remove 6 bolts (1) and gear housing (2).
39. Crankshaft
a Before removing the crankshaft, measure
its end play with tool L.
1) Remove mounting bolts (2) of main cap
(1).
2) Mark the position No. on main cap (1).
a Check that the embossed letters of
"BACK" on side (A) of the main cap
are directed toward the rear of the
cylinder block.
114E-3 Series
3) Insert bolts (2) in the bolt holes of main
cap (1) and remove the main cap, while
shaking it.
4) Remove lower bearing (3) from main cap
(1).
a Mark the position No. in part (A) of
the claw of the removed bearing (Do
not enter it in the sliding portion of the
bearing).
SEN00463-01
15