Komatsu 114E-3 Series Shop Manual page 322

SEN00464-01
6) Remove the seal mounting pilot tool.
7) Cut off gasket (5). (Right and left)
a Take care that the cut gasket will not
fall in the engine.
16. Oil pan
Fill the spaces a between the cylinder
1)
block and gear housing and between the
cylinder block and rear seal housing with
gasket sealant.
2) Install bed plate (4) to block (5).
2
Bed plate (Mating surface with cyl-
inder block):
Application drawing of gasket sealant
q
Diameter of gasket sealant string:
Apply strings of gasket sealant 1 mm
in diameter to the range from the bolt
hole center to the area of R7. Change
the diameter of the gasket sealant
smoothly from 1 mm to 3 mm for the
other parts unless otherwise speci-
fied.
14
Gasket sealant (LG-7)
50 Disassembly and assembly
3) Apply gasket sealant to the bed plate mat-
ing face shown in the figure and install
gasket (6).
2
Gasket (Mating face of bed plate):
a Apply gasket sealant (strings) simi-
larly to step 2).
Gasket sealant (LG-7)
114E-3 Series