Komatsu 114E-3 Series Shop Manual page 297

50 Disassembly and assembly
5) Remove 4 nuts (5) and 1 bolt (6).
6) Push in tool P installed in step 4) to
remove supply pump assembly (7).
20. Rocker arm assembly and crosshead
1) Remove 12 bolts (1) and rocker arm
assembly (2).
a Loosen the locknut and then loosen
the adjustment screw by 2 – 3 turns
so that an excessive force will not be
applied to the push rod when the
rocker arm is installed.
2) Remove crosshead (3).
a Record the position of each cross-
head and the shapes of holes (a) and
(b).
114E-3 Series
21. Fuel injector assembly
a Before removing the inlet connector,
remove all mud, etc. sticking around it so
that mud, etc. will not enter the hole of the
connector.
1) Remove retainers (1) and 6 inlet connec-
tors (2).
Use tool M to remove the inlet con-
q
nectors.
Before removing retainer (1) of the
q
No. 6 cylinder, remove rear engine
hanging plate (3).
SEN00463-01
7