Table of Contents
Advertisement
CHAPTER
4
Getting Ready for the Start-up
Honeywell Analytics loads all software on the DAq at the factory. The Universal Chemcassette
Analyzers are configured for the mineral acid family of gases. You need to configure each point
for the target gases at your facility.
Before you begin the start-up and configuration, gather the following information:
The location to which each point is connected
l
Target gas at each location
l
Alarm levels
l
Ahead of the start-up sequence, make sure that the following installation steps are completed:
Sample lines connected
l
Exhaust line connected
l
AC power connection
l
Sample Line Dust Filters installed
l
I/O Connection
l
Initial Startup
Use this section to turn on yourVertex Edge System and to configure the analyzer modules for
specific gas locations. There are eight parts to this startup procedure:
Power Up
l
Start Program
l
Log in the HMI program
l
Create a configuration profile
l
Replace the Chemcassette Tape
l
Leak Checking Sample Lines
l
Adjust the Flow rate
l
Adjust Supply Vacuum
l
Start Program
Upon power-up, the DAq automatically starts Linux and loads the Vertex Edge HMI program. After
the startup sequence, the Vertex Edge HMI main screen opens as below. The start-up time may
take several minutes, and the default user is Viewer.
Vertex Edge System
Device Operations
46
User Manual
Advertisement
Table of Contents
