Table of Contents
Advertisement
CHAPTER
4
Learn what you can do with your Honeywell Vertex™ Edge System Continuous Monitor.
Getting Ready for the Start-up
Learn the Honeywell Vertex™ Edge system start-up sequence and how to configure the analyzer
modules for specific gas locations.
Honeywell Analytics loads all software on the DAq at the factory. The Universal Chemcassette
Analyzers are configured for the mineral acid family of gases. You need to configure each point
for the target gases at your facility.
Before you begin the start-up and configuration, gather the following information:
The location to which each point is connected
l
Target gas at each location
l
Alarm levels
l
Ahead of the start-up sequence, make sure that the following installation steps are completed:
Sample lines
l
Exhaust line
l
AC power connection
l
Sample Line Dust Filters
l
I/O Connection
l
Vertex Edge System
Device Operations
43
User Manual
Advertisement
Table of Contents
