13.
With the power connector removed and the vacuum and exhaust tubing connections
removed, push the drawer back to the locked position. (This will prevent the drawer from
moving while swapping out the pump)
14.
Pull up on the locking pin holding the pump plate in place
15.
While the locking pin is pulled up, pull back on the pump plate to remove the pump
(Note: The picture shown has the pump drawer opened and unlocked. This orientation is to
show the pump pin and plate. This step should be performed in the locked position. The
locked position will prevent the drawer from moving while swapping out the pump.)
Vertex Edge System
114
User Manual