External Printers - Thermo Scientific GENESYS 10S Vis User Manual

External Printers

Thermo Scientific
Note Make sure the paper roll holders are in place as shown. When installed correctly,
they fit flush with the top of the instrument.
To load paper in the internal printer
1. Cut the paper so the edge is even.
Note Arrows on the paper roll holders indicate the direction of the paper feed.
2. Feed the paper straight into the paper entry slot.
The printer grabs the end of the paper and pulls it in.
3. In Basic ATC mode, when the paper stops, press Enter to continue advancing the paper
until the paper comes out of the paper exit slot.
4. Pull out on the finger tabs on the paper roll holders and secure the roll of paper onto the
paper roll holder.
Your spectrophotometer is able to print to external desktop printers supporting HP PCL 5.0
format and later.
Note PCL format does not support HP "Windows" printers.
To print to an HP PCL printer, connect the USB cable to the printer and to the USB port on
the back of the instrument (see
Note The instrument is compatible with most HP PCL printers; brands other than HP
will also be supported. If the printer is not purchased from Thermo Scientific, it is your
responsibility to determine if the printer is compatible with the instrument. Contact
technical support or your sales representative for more information.
"Connectors" on page 1).
3
Accessories
External Printers
GENESYS 10S Vis User Guide 23