TA Instruments TGA 2950 Operator's Manual page 38

Installing the 2950
Figure 2.2
Removing the Plywood
Board
2–4
1. Open the shipping carton and remove the
accessory box.
2. Remove the cardboard packing insert.
3. Stand at one end of the box with your
assistant facing you at the other end. Lift
your end of the unit out of the box as your
assistant lifts his/her end.
4. Place the unit on a lab bench with one side
hanging over the edge of the bench (see
Figure 2.2). Someone must be holding
onto the unit at all times while it is in this
position.
5. While your assistant holds the unit, use a
wrench to remove the two nuts and washers
from the bottom. Then lift and rotate the
unit so that the other end hangs over the
edge of the bench. Someone must hold
onto the unit at all times while it is in
TA I TGA 2950
NSTRUMENTS